pack of 1 Stainless steel ball for safety valves check valves etc, these are pure stainless so will not rust.
1/2 dia stainless steel balls 316 grade
pack of 1 Stainless steel ball for safety valves check valves etc, these are pure stainless so will not rust.
5/8 dia stainless steel balls 316 grade
pack of 1 Stainless steel ball for safety valves check valves etc, these are pure stainless so will not rust.
1/16 dia stainless steel balls 316 grade pack of 5
pack of 5 Stainless steel balls for safety valves check valves etc, these are pure stainless so will not rust.
No.3 Injector Horizontal 3/4 pints per min 5/32 pipe
No.3 3/4 pints/min. 5/32" pipe These are tested upto 120 PSI, and work from 30psi and lower, unto 120psi and higher made by David English Fitting the injector The steam feed, water and delivery tubes, should be copper to suit. The steam and delivery tubes should be kept as short as
Kennedy MULTI-ANGLE SOFT JAW VICE
Aluminium vice with a two position lockable ball joint, cast steel clamp and swivel mechanism. Horizontal/vertical grooved jaw is designed to hold irregular shaped objects. Removable jaw rubber covers for protecting delicate components. Will clamp to surfaces of five to 50mm thickness. Jaw width:
No.5 Injector Horizontal 3/8 x 32 thread for 1/4 pipe
No.5 injector. 1/4" pipe Fitting the injector The steam feed, water and delivery tubes, shoud be copper to suit. The steam and delivery tubes should be kept as short as possible, and any bends must be large enough radius to ensure that the bore is not restricted. The feed check valve should
UG70009 Ugears Model Pneumatic engine
Ugears Model Pneumatic engine Be a part of the once great era of steam with just a breath of air. The Pneumatic Engine is a small but fully functional example of a steam engine, except it uses air pressure instead of steam to set it in motion. Use an ordinary inflated balloon and watch the pistons